User Guide - shadowregs
This user’s guide describes how to use shadowregs application.
Command line interface
shadowregs
NXP Shadow Registers control Tool.
shadowregs [OPTIONS] COMMAND [ARGS]...
Options
- -i, --interface <interface>
The interface allow specify to use only one debug probe interface like: ‘PyOCD’, ‘jlink’ or ‘pemicro’
- -v, --verbose
Print more detailed information
- -vv, --debug
Display more debugging information.
- --version
Show the version and exit.
- --help
Show this message and exit.
- -s, --serial-no <serial_no>
Serial number of debug probe to avoid select menu after startup.
- -dev, --device <device>
The target device family.
- Options
rt5xx | rt6xx | rw61x
- -r, --revision <revision>
Chip revision; if not specified, most recent one will be used
- -o, --debug-probe-option <debug_probe_option>
This option could be used multiply to setup non-standard option for debug probe.
The example of use: -o KEY=VALUE
[jlink]:
[frequency]: Set the communication frequency in KHz, default is 100KHz
[pemicro]:
[frequency]: Set the communication frequency in Hz, default is 100_000Hz
fuses-script
The command generate BLHOST script to burn up fuses in device by configuration.
The OUTPUT argument specify file name of generate BLHOST burn fuses script.
shadowregs fuses-script [OPTIONS] OUTPUT
Options
- -c, --config <config>
Required The name of shadow register configuration file used to generate burn fuses BLHOST script.
Arguments
- OUTPUT
Required argument
get-template
Generate the template of Shadow registers YAML configuration file.
shadowregs get-template [OPTIONS] PATH
Options
- -r, --raw
In loaded configuration will accepted also the computed fields and anti-pole registers.
Arguments
- PATH
Required argument
getreg
The command prints the current value of one shadow register.
shadowregs getreg [OPTIONS]
Options
- -r, --reg <reg>
Required The name of register to be read.
info
The command generate HTML of Shadow registers.
shadowregs info [OPTIONS]
Options
- -o, --output <output>
Required File name of generated output HTML description file
- -p, --open
Open the generated description file
loadconfig
Load new state of shadow registers from YAML file into microcontroller.
shadowregs loadconfig [OPTIONS]
Options
- -f, --filename <filename>
Required The name of file used to load a new configuration. Default name is ‘sr_config’. The extension is always ‘.yaml’.
- -r, --raw
In loaded configuration will accepted also the computed fields and anti-pole registers.
- --verify, --no-verify
Verify write operation (verify by default)
printregs
Print all Shadow registers including theirs current values.
In case of needed more information, there is also provided rich format of print.
shadowregs printregs [OPTIONS]
Options
- -r, --rich
Enables rich format of printed output.
reset
The command resets connected device.
shadowregs reset [OPTIONS]
saveconfig
Save current state of shadow registers to YAML file.
shadowregs saveconfig [OPTIONS]
Options
- -f, --filename <filename>
The name of file used to save the current configuration. Default name is ‘sr_config’. The extension is always ‘.yaml’.
- -r, --raw
The stored configuration will include also the computed fields and anti-pole registers.
- -d, --save-diff
Save differences comparing to defaults
setreg
The command sets a value of one shadow register defined by parameter.
shadowregs setreg [OPTIONS]
Options
- -r, --reg <reg>
Required The name of register to be set.
- -v, --reg-val <reg_val>
Required The new value of register in hex format.
- --verify, --no-verify
Verify write operation (verify by default)